RJ-45
>>Have you ever been frustrated
by the long wires/jumpers used in manual
robots??
The non-rigid and lengthy wires sometimes combines with each
other and may result in blocking the movement of the robot.
So,
here is the solution—RJ 45
What is RJ-45?
--A RJ-45 is an
8 wired bundled wire mainly used for
wired internet network. As it is quite rigid
than other wires, it can be used for manual robots. This wire does not allow other noises to pass
through it. Hence it can be a quite handy tool for electronics hobbyists.
Make a
female connector for RJ-45
--Here is
the PCB circuit for female connector of RJ-45 with simple 0.1inch connector for
the circuits.
The female connector consist of 4 upper pins and 4 lower
pins. The distance between two pins is 2.5 mm as shown in figure. Also, the
distance between upper pins and lower pins is 2.5 mm.
*Note: The
male connector which goes on the wire itself can be attached in any electrical
shop which just costs around $0.1.
0 comments:
Post a Comment